Dewalt DW7450- Manuel d'utilisation

DW7450 Heavy-Duty Table Saw Stand

WARNING:

For your own safety, read the

table saw instruction

manual before using any accessory. Failure to heed these warn-
ings may result in personal injury and serious damage to the table
saw and the accessory. When servicing this tool, use only identical
replacement parts.

• This table saw stand is designed only for use with the DW745

table saw. Do not use this stand with any other tool.

• DO NOT mount the table saw to the stand in any other

orientation.

• Position all of the feet in the same orientation or unstable

footing may occur.

• Do not climb on or sit on saw stand.
• Do not use saw stand on inclined, uneven or unstable surfaces.
• Do not use saw stand if it is damaged or bent.
• The back legs of the saw stand are slightly longer than the

front legs to provide additional support. Use the saw stand
and operate the table saw from the front side only.

• Maximum load: 150 lbs. (68.1 kg.)

SAVE THESE INSTRUCTIONS

ASSEMBLY

• Assemble as shown in Figure 1.

TO OPEN TABLE SAW STAND

1. Unfold the saw stand until it is fully opened. Place it upright, as

shown in Figure 2.

2. Place the table saw on the stand. Place the front bar of the saw

into the lip (A) on the front of the stand (Fig. 3).

3. Lower the rear feet of the saw onto the ledge (B) at the back of

the stand as shown in Figure 3.

4. Secure the rear of the saw with the bolts provided (Fig. 4). Be

sure the saw does not rock or wobble in place.

TO CLOSE THE STAND

1. Remove the bolts from the rear rail of the saw.
2. Tilt the rear of the saw up allowing the rear feet to clear the lip

on the back of the stand.

3. Pull the saw forward and up allowing the front bar to slide out of

the lip on the stand.

4. After stowing the saw, pick the stand up by both rails and close

it by squeezing the top rails toward each other.

FIG. 1

D

E

WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 (JAN07) Form No. 645631-00 DW7450 Copyright © 2006, 2007 D

E

WALT

The following are trademarks for one or more DeWALT power tools: the yellow and black color scheme; the “D” shaped air intake grill; the array of pyramids
on the handgrip; the kit box configuration; and the array of lozenge-shaped humps on the surface of the tool.

FIG. 2

FIG. 4

FIG. 3

A

B

Socle robuste DW7450 pour
scie de table

AVERTISSEMENT :

pour votre propre sécurité, lire le mode

d’emploi de la scie de table avant d’utiliser tout accessoire. Négliger
de se conformer à ces avertissements pourrait se solder par des
blessures corporelles et des dommages importants à la scie de
table et à l’accessoire. Pour la réparation de cet outil, n’utiliser que
des pièces de rechange identiques.

• Ce socle pour scie de table est conçu uniquement pour le

modèle de scie de table DW745. Ne pas utiliser le socle avec
tout autre outil.

•

NE PAS assembler la scie de table sur le socle dans une
direction différente.