GE GYE22GYNFS - Manuel d'utilisation - Page 10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80

Page: / 80 Aller à

Page précédentePage suivante

PDF Texte

Téléchargement du manuel

36

49-60792 Rev. 4

AT-2

LOCATING THE ANTI-TIP

FLOOR BRACKET (cont.)

5HFRPPHQGHG,QVWDOODWLRQ

– Wood

5HFRPPHQGHG,QVWDOODWLRQ

– Concrete

Minimum Acceptable #1 –

Wall Plate Stud

Minimum Acceptable #2

±:RRG)ORRU

Minimum Acceptable #3

±&RQFUHWH)ORRU

)LJXUH± $FFHSWDEOH6FUHZ3ODFHPHQW

Locations

&21&5(7(:DOODQG)ORRU&RQVWUXFWLRQ
‡$QFKRUVUHTXLUHGQRWSURYLGHG

HDFK´PP[´PPODJEROWV
HDFK´PP2'VOHHYHDQFKRUV

‡'ULOOWKHUHFRPPHQGHGVL]HKROHVIRUWKH

anchors into the concrete at the center of the
holes marked in Step 2.

•

,QVWDOOWKHVOHHYHDQFKRUVLQWRWKHGULOOHGKROHV

Place the anti-tip floor bracket as indicated in Step
2. Remove the locator template from the floor.

‡,QVWDOOWKHODJEROWVWKURXJKWKHDQWLWLSIORRU

bracket and tighten appropriately.

:22':DOODQG7,/()ORRU&RQVWUXFWLRQ
‡)RUWKLVVSHFLDOFDVHORFDWHWKHZDOOKROHV

LGHQWLILHGLQ)LJ'ULOODQDQJOHG´PP
SLORWKROHDSSUR[DVVKRZQLQ)LJLQWKH

center of each hole.

• Mount the anti-tip floor bracket using the

0LQLPXP$FFHSWDEOH,QVWDOODWLRQDV
LOOXVWUDWHGLQ)LJ

C

B

AT-3

ANTI-TIP BRACKET
INSTALLATION

:22':DOODQG)ORRU&RQVWUXFWLRQ
‡'ULOOWKHDSSURSULDWHQXPEHURI´PP

pilot holes in the center of each floor bracket
hole being used (a nail or awl may be used if

DGULOOLVQRWDYDLODEOH$1'UHPRYHWKHORFDWRU

template from the floor.

• Mount the anti-tip floor bracket by fastening the

2, or recommended 4, #10-16 hex-head screws

WLJKWO\LQWRSODFHDVLOOXVWUDWHGLQ)LJXUH

A

AT-4

POSITIONING THE
REFRIGERATOR TO ENGAGE
THE ANTI-TIP FLOOR AND
BASE BRACKETS

Before pushing the refrigerator into the opening,
plug the power cord into the receptacle and

FRQQHFWZDWHUOLQHLIHTXLSSHG&KHFNIRUOHDNV

Locate the refrigerator’s RH side and move back
approximately in line with the RH side of the
cabinet opening, W. This should position the
anti-tip floor bracket to engage the anti-tip base
bracket on the refrigerator.
Gently roll the refrigerator back into the cabinet
opening until it comes to a complete stop.
Check to see if the refrigerator front lines up

ZLWKWKHFDELQHWIURQWIDFH,IQRWFDUHIXOO\URFN

the refrigerator forward and backward until
engagement occurs and you notice that the
refrigerator is fully pushed up against the rear wall.

If Applicable:

$GMXVWWKHUHDUDQGIURQWZKHHO

height settings to fully engage the rear anti-tip
brackets, while also aligning the refrigerator
front with the cabinet front face.

A

C

B

'

)LJXUH± $WWDFKPHQWWR:DOODQG)ORRU

NOTE:

,I\RXSXOOWKHUHIULJHUDWRURXWDQG

away from the wall for any reason, make sure
the anti-tip floor bracket is engaged when the
refrigerator is pushed back against the rear wall.

Rear RH Corner

of the Refrigerator

)ORRU

Wall

Plate

Stud

)ORRU

Bracket

2 Screws

Must Enter

Wood or

Metal Stud

Wall

Installation Instructions

INSTALLING THE REFRIGERATOR (Cont.) Anti-Tip Floor Bracket Installation
(Models PYE, GYE, GYS, GWE, DYE, PYD, PWE, and ZWE only)

INST

ALLA

TION INSTRUCTIONS

Autres modèles de réfrigérateurs GE

• GE GFD28GELDS
  • Manuel d'utilisation
• GE GFD28GYNFS
  • Manuel d'utilisation
• GE GFE28GELDS
  • Manuel d'utilisation
• GE GFE28GYNFS
  • Manuel d'utilisation
• GE GIE17GSNRSS
  • Manuel d'utilisation
• GE GIE18DTNRBB
  • Manuel d'utilisation
• GE GIE18DTNRWW
  • Manuel d'utilisation
• GE GIE18GCNRSA
  • Manuel d'utilisation
• GE GIE18GSNRSS
  • Manuel d'utilisation
• GE GIE18GTNRBB
  • Manuel d'utilisation