Wagner 2428336 - Manuels - manuelsdutilisation.com

Page 2 - RISQUE D’EXPLOSION OU D’INCENDIE

3 IMPORTANT SAFETY INFORMATION • IMPORTANTES CONSIGNES DE SÉCURITÉ • INFORMACIÓN IMPORTANTE SOBRE SEGURIDAD a. The pins on plug of extension cord are the same number, size, and shape as those of plug on charger. b. The extension cord is properly wired and in good electrical condition. c. The wire si...

Page 4 - LISTE DES BATTERIES/CHARGEURS; ¡ADVERTENCIA! ADVERTENCIA DE LA PROPUESTA 65 DE CALIFORNIA; PELIGRO: EXPLOSIÓN O INCENDIO

5 IMPORTANT SAFETY INFORMATION • IMPORTANTES CONSIGNES DE SÉCURITÉ • INFORMACIÓN IMPORTANTE SOBRE SEGURIDAD et peut rayonner de l’énergie de fréquence radioélectrique et, s’il n’est pas installé et utilisé conformément aux instructions, il risque de causer des perturbations nuisibles aux communicati...

Page 6 - SETUP • MONTAGE • PREPARACIÓN

8 SETUP • MONTAGE • PREPARACIÓN THINNING THE MATERIAL Before spraying, the material being used may need to be thinned with the proper solvent as specified by the material manufacturer. Never exceed the thinning advice given by the coating manufacturer.If thinning is necessary, use water or paint con...

Page 8 - SPRAYING • PULVÉRISATION • ROCIADO; Correct; iSPRAY

10 SPRAYING • PULVÉRISATION • ROCIADO STOP It is important to keep your arm moving whenever the gun is being triggered. If you pause or linger in one spot too long, too much material will be sprayed to the surface. • Turn the ON/OFF switch to ON (I) to turn on the turbine. No material will spray unt...

Page 9 - CLEANUP • NETTOYAGE • LIMPIEZA; DETAIL FINISH

11 CLEANUP • NETTOYAGE • LIMPIEZA i When cleaning, use the appropriate cleaning solution (warm, soapy water for water-based coatings, and mineral spirits for oil-based coatings. Special cleanup instructions for use with flammable solvents (must have a flashpoint above 100˚F (38˚C): • Always flush sp...

Page 10 - REPLACING THE FILTER; REMPLACEMENT DU FILTRE; REEMPLAZO DEL FILTRO; PROBLEM

TROUBLESHOOTING 12 MAINTENANCE • ENTRETIEN • MANTENIMIENTO REPLACING THE FILTER Attention Before every use, you should inspect the air filter in the turbine to see if it is excessively dirty. If it is dirty, follow these steps to replace it.Never operate your unit without the air filters. Dirt could...

Page 13 - PRODUCT REGISTRATION / DATE CODE LOCATION

16 WARRANTY • PAINT SPRAY EQUIPMENT This product, manufactured by Wagner Spray Tech Corporation (Wagner), is warranted against defects in material and workmanship for one year following date of purchase if operated in accordance with Wagner’s printed recommendations and instructions. This warranty d...

Wagner 2428336 - Manuels

Manuels:

Manuel d'utilisation Wagner 2428336

Résumé

Other Wagner Pulvérisateurs de peinture Manuals